![]() ![]() ![]() The last thing that we need to do before we login and start using NextCloud is tell NextCloud that we can trust the ip address nextcloud. The problem is due to apparmor.Īfter we use snap to download nextcloud we need to run some command to setup and finish installing nextcloud nextcloud.manual-install This is what it will look like if it fails. to do this you are going to use the command below. Now it is time to install your snap package. ![]() Now with the CT up to date it is time to install the software that we will use to install snap packages to do this use the command apt install squashfuse snapd -y To update the CT enter the command apt update & apt upgrade -y To log in enter a username of root and the password that was entered in the CT setup. Just follow the like 3 steps on the Jellyfin website. Passthrough a mount, snap and replicate your collection via ZFS for backups, profit. Sharing files (SMB) works fine, or is not noticeable, but the database is very slow. The server is used for share files (SMB) and a file based database (+500k small files) over SMB. There was no need of a VM or LXC just for this. To start your CT click Start, then Console to display a command promote. Docker adds an additional unnecessary layer. To make it simple, mdadm and samba was installed on host. Select your new CT under the drop down for your server, then select Options and under Options select Features and click Edit.Ī window like this will appear and select FUSE and click OK When the CT is fully setup it will say TASK OK close the window. If your Proxmox server was setup right when installing your should not have to fill out this page, so click Next Then enter the address to the gateway on most home networks this will be the ip address for your router. Set the amount of RAM to use for your CT.Įnter the IP address fallowed by the CID sub net mass for most home networks smaller then 254 systems this most likely will be /24. Select the drive that you will store the CT on and set the max size for the CT. With CT Templates open select the image that you plan on using for this guide I will be using Ubuntu 22.04, after selecting the image click download.Īfter your image is downloaded it will show up in the CT Templates folder of the local drive.Įnter the hostname for you CT or container, then fill out your root password, finish by clicking Next.Īt this screen select the Template that you downloaded. Then go down to local and select it, then select CT Templates, after selecting CT Templates, select Templates. to do that open the dropdown for your server labeled here as R2D2. The first step in setting up a container is to get the image that we will use for the container. If you are going to run snap in a Proxmox container the first thing that you are going to need to have is a container if you already know how to make a container you can skip to the point where we are installing software. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |